Edge-Core ECS4110-28T, Management Manual, Page: 1010 / 1514

C
HAPTER
27
| Interface Commands
Transceiver Threshold Configuration
– 1010 –
E
XAMPLE
Console(config)interface ethernet 1/52
Console(config-if)#transceiver-monitor
Console#
transceiver-
threshold-auto
This command uses default threshold settings obtained from the
transceiver to determine when an alarm or warning message should be
sent. Use the no form to disable this feature.
S
YNTAX
transceiver-threshold-auto
D
EFAULT
S
ETTING
Disabled
C
OMMAND
M
ODE
Interface Configuration (SFP Ports)
E
XAMPLE
Console(config)interface ethernet 1/52
Console(config-if)#transceiver-threshold-auto
Console#
transceiver-
threshold current
This command sets thresholds for transceiver current which can be used to
trigger an alarm or warning message.
S
YNTAX
transceiver-threshold current { high-alarm | high-warning |
low-alarm | low-warning } threshold-value
high-alarm – Sets the high current threshold for an alarm
message.
high-warning – Sets the high current threshold for a warning
message.
low-alarm – Sets the low current threshold for an alarm message.
low-warning – Sets the low current threshold for a warning
message.
threshold-value – The threshold of the transceiver current.
(Range: 0-13100 in units of 0.01 mA)
D
EFAULT
S
ETTING
High Alarm: 100 mA
HIgh Warning: 90 mA
Low Warning: 7 mA
Low Alarm: 6 mA