Edge-Core ECS4110-28T, Management Manual, Page: 1429 / 1514

C
HAPTER
46
| IP Interface Commands
IPv4 Interface
– 1429 –
ARP C
ONFIGURATION
This section describes commands used to configure the Address Resolution
Protocol (ARP) on the switch.
arp
This command adds a static entry in the Address Resolution Protocol (ARP)
cache. Use the no form to remove an entry from the cache.
S
YNTAX
arp ip-address hardware-address
no arp ip-address
ip-address - IP address to map to a specified hardware address.
hardware-address - Hardware address to map to a specified IP
address. (The format for this address is xx-xx-xx-xx-xx-xx.)
D
EFAULT
S
ETTING
No default entries
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
◆
The ARP cache is used to map 32-bit IP addresses into 48-bit hardware
(i.e., Media Access Control) addresses. This cache includes entries for
hosts and other routers on local network interfaces defined on this
router.
◆
The maximum number of static entries allowed in the ARP cache is 128.
◆
You may need to enter a static entry in the cache if there is no response
to an ARP broadcast message. For example, some applications may not
respond to ARP requests or the response arrives too late, causing
network operations to time out.
◆
Static entries will not be aged out nor deleted when power is reset. A
static entry can only be removed through the configuration interface.
E
XAMPLE
Console(config)#arp 10.1.0.19 01-02-03-04-05-06
Console(config)#
Table 212: Address Resolution Protocol Commands
Command Function Mode
arp Adds a static entry in the ARP cache GC
ip proxy-arp Enables proxy ARP service IC
clear arp-cache Deletes all dynamic entries from the ARP cache PE
show arp Displays entries in the ARP cache NE, PE