edenox EXPONORM 651, Installation, Use And Maintenance Manual

Page: 7 / 20

I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO
7
Operator's guide
7. CONNECTION TO THE MAINS
1. (A)
Ensure that mains voltage and frequency are the same as those stated on the rating plate attached
to the appliance. Ensure that the supply socket has the following characteristics:
2.
a) it is properly
earthed. It fulfils the requirements of the rated current as set out on the rating plate. It complies with b) c)
the IEC regulations: - magnetothermal differential switch (also known as ground fault interrupter) with In
= nominal value as stated on the rating plate; - Differential with Id sensitivity = 30 mA.
Ensure that
3.
there is no danger of explosion (AD) in the room. The connecting cable to the appliance is H05 VVF
4. ,
designed for internal use. For installation in any other environments, it will be necessary to change the
cable with the appropriate type (for example H07 VVF for external use).
If during transport or
N.B.
storage the appliance has been placed by mistake in a horizontal position or has been turned upside
down, leave for at least three hours in the correct position before switching on the power supply.
5.
Connect the plug (do not use three-way adapters and reduction adapters) (see figure 6).
8. CONTROLS
The appliance is supplied with adjusting controls situated in a protected panel on the front.
1. Refrigeration switch: 2. Light switch:
to switch on the refrigeration system. to switch on the light
inside the cabinet. to display the temperature in the appliance. to adjust
6. Thermometer: Thermostat:
the temperature in the appliance. Press button once to display the temperature set-point,
a) 3
“
SET or P
”
which can be changed by pressing button or button (see figure 7).
4
“
UP
”
5
“
DOWN
”
9. CHECKING CORRECT OPERATION
CHECK THAT: 1. 2. 3.
The plug is connected. The refrigeration unit is switched on (green light on). The
thermometer shows the desired temperature for the goods to be stored. The appliance is not exposed
4.
to direct sunlight or to high-powered lamps. The room temperature does not exceed that in which the
5.
appliance is designed to work normally, i.e. +30°C, 55% r.h. (climatic class 4).
10. REPLACING THE INTERNAL LIGHTS
1. 2. 3.
Switch off the appliance. Unscrew the screws fixing the upper lamp socket. Detach the upper
lamp socket from the fluorescent tube with the transparent cover. Slide the tube out from the lower
4.
lamp socket. Remove the transparent cover. Replace the fluorescent tube. Refit all parts in
5. 6. 7.
reverse order (see figure 8).
11. REPLACING THE DOOR'S MAGNETIC GASKET
1. 2. 3.
Open the door. Take hold of the magnetic gasket and pull it out of the frame. Insert the new
gasket and press it firmly down all around (see figure 9).