Eden HA700, Manual

Page: 9 / 23

9
*1: During alarm condition, LED flashes once every second.
*2: LED will flash according to the corresponding zone number.
*3: The low battery LED can be cleared when the system enters test mode.
*4: Under chime mode, it will reveal via UI_Dingdong.
*5: Zone trigger will be occurred only under arm mode. Tamper and panic will be triggered in any mode. Alarm memory can be
cleared after re-entering arm mode.
*CP: Means Control Panel
REMOTE CONTROLLER
A LED indicator E Panic Switch
B Arm F Key Chain Ring
C Part-Arm G Negative Polarity
D Disarm H Positive Polarity
The Remote Controller is used to Arm, Part-Arm and Disarm the system.
The Remote Controller also incorporates a Panic switch. Activating the Panic switch will immediately initiate a Full
Alarm condition whether the system is Armed or Disarmed, (unless the system is in Test mode).
The Remote Controller adopts a CR2032 type Lithium cell which under normal conditions will have typical life in
excess of 1 year. Under normal battery conditions the LED on the Remote controller will only illuminate when a
button is pressed. However, under low battery conditions this LED will flash every time the button is pressed.
When this occurs the batteries should be replaced as soon as possible.
SETTING THE REMOTE CONTROLLER
1. Remove the rear cover with a coin.
2. Insert the battery ensuring that the +v terminal faces upwards away from the PCB.
3. Replace the rear cover.