17
PROGRAMMING INSTRUCTIONS
ARM MODE
Press
User access code
Upon receipt of trigger signal, the Control Panel will
generate alarm condition right away.
Using remote controller, wireless keypad or press
keypad on the
User access code
Control Panel can disarm the alarm condition.
PART-ARM MODE
Press
User access code
Upon receipt of trigger signal from Zone 1, the Control
Panel will initiate full alarm condition.
Using remote controller, wireless keypad or press
keypad on the
User access code
Control Panel can disarm the alarm condition.
CHIME MODE
Press
User access code
Upon receipt of trigger signal from the detectors, the
Control Panel will ding dong twice.
DISARM MODE
Default setting: DISARM
Press
User access code
When full alarm condition occurs, disarm the alarm
using remote controller, wireless keypad or the keypad
on the Control Panel as mentioned above.
RECORDING ALARM MESSAGE
Press
User access code
Start recording message after beep is heard. Press any
keypad to stop recording. The maximum allowable
length of recording an alarm message is 6 seconds.
USER ACCESS CODE
Default setting: 1 2 3 4
Press
Default access code
Press
User access code
Press a new 4-digit user access code and then
within 15 seconds. This 15-second allows users to
enter a new access code. If a sequence of incorrect
access code is entered 3 times, the Control Panel will
exit this mode.
Press
to exit
Any 4-digit
user access code mode.
PHONE NUMBER
Press
User access code
The maximum allowable length of inputting a set of
phone number is 30 seconds. Press
right after
the completion of each set of telephone number as
Summary of Contents for HA700
Page 23: ...23...
