Eden HA700, Manual

Page: 6 / 23

6
further consideration should be given to keeping
the units out of their reach.
3. The Control Panel should be mounted within a
protected area so that any intruder cannot reach
the Control Panel without opening a protected door
or passing through an area protected by Motion
Sensor when the system is armed.
4. The Control Panel must be located within reach of
a mains socket.
5. Do not locate the Control Panel closer than 1m to
any large metallic object, (e.g. mirrors, radiators,
etc) as this may affect the radio range of the
Control Panel.
MOUNTING THE CONTROL PANEL
1. Unscrew the screw on the bottom of L-shaped
metal mounting bracket so as to detach it from the
Control Panel.
Note: DO NOT undo the screw on the metal
mounting bracket completely.
2. Use one finger from each hand to remove the
battery cover from the rear of Control Panel.
3. Fit 4 batteries to the battery compartment and
ensure correct polarity.
4. Refit battery cover.
5. Connect the Control Panel to the telephone
connection lead by inserting small RJ11 plug into
socket. Route the cable along the cable track.
6. Affix enclosed fixing template to the position where
the Control Panel is to be mounted. Mark the
positions of 4 fixing holes on the wall. Drill four
6-7mm diameter holes and fit plastic wall plugs into
the holes.
7. Fit two screws into the top holes until almost fully
home leaving 2mm length outside. Secure
L-shaped metal mounting bracket to the wall using
two remaining screws provided. Hang the Control
Panel over two top screws using the two keyhole
slots in the top corners of the panel casing and pull
148
45
1
0
7