18
confirmation. During input, any incorrect digit number
can be erased by pressing
each time. Up to 4
set of phone numbers can be memorized.
KEY TONE
This feature, if enabled, allows the Control Panel to be
emitted a tone each time the keypad is pressed.
Default setting: key tone enable
Press
to disable
User access code
key tone.
Press
again to
User access code
enable key tone.
CLEARING PHONE NUMBER
Press
User access code
The maximum allowable length of clearing all preset
phone numbers is 15 seconds. Once finished, refers
to “UI_Success” for confirmation.
LEARNING ID CODE / ZONE ASSIGNMENT
Press
User access code
The Control Panel will enter learning mode of which UI
indication refers to “UI_Wait”. The Control Panel has
a 30-second to learn one ID code from the
detector/remote controller/wireless keypad.
For detector, press the tamper switch on the detector
so as to emit ID code to the Control Panel.
Three LED will flash in sequence on the Control Panel,
it helps you to determine which zone the detector
should be assigned. Users have a 6-second to input
zone number. If the detector is to be assigned in Zone 1,
press keypad
; Zone 2, press keypad
;
whereas Panic zone, press keypad
on the
Control Panel.
Note: It is recommended that the smoke detector and
flood detector are assigned to panic zone.
For wireless keypad, press the tamper switch on the
device so as to emit ID code to the Control Panel
automatically.
For remote controller, press any key on it so as to emit
ID code to the Control Panel automatically.
If failed refers to UI_Error indication for confirmation.
CLEARING ID CODE
Press
User access code
The Control Panel will enter clearing mode of which UI
indication refers to “UI_Wait”. Users have 15-second
to clear ID code.
Following is the instruction to clear ID code stored in
each zone.
Press
for zone 1
User access code
Press
for zone 2
User access code
Press
for panic
User access code
Press
for remote
User access code
Press
for keypad
User access code
Press
for all ID
User access code
ACTIVATION TYPE 1
This feature allows the siren and dialer take action
simultaneously when the Control Panel is triggered
configured for arm or part-arm mode.
Summary of Contents for HA700
Page 23: ...23...
