46
- Inspection and possible replacement of the door rope;
- Disassembling and cleaning of the T junction of the exhaust gas system;
- Inspection of all electronic parameters;
- Issue of a certificate for the completed inspection
.
ATTENTION
Do not clean the system until completely cooled down.
Periodical cleaning of the OUTER SURFACE, GLASS, DOOR ROPE, ASH DRAWER
Daily cleaning of the BURNER, EXCHANGER
Monthly cleaning of the RESERVOIR
After the use of 1800 kg pellets, cleaning of ALL SYSTEMS OF EXHAUST GASES AND FRESH AIR.
OUTER SURFACE
Use soft cloth and neutral detergents.
GLASS
Glass is cleaned by itself during the operation of the pellet stove. However, it is possible, after few hours of
operation the glass to become dirty on the inner side, depending on the quality of the pellets and the exhaust
gas system. In that case use cotton cloth or magazine paper with a small quantity of detergent for glass
cleaning. This cleaning should be performed only when the pellet stove is cooled down. After each cleaning
check the glass if there is a distance of 2 mm between the glass and the upper edge (see figure).
DOOR ROPE
The rope guarantees airthightness of the door and proper operation of the pellet stove. It is good to check the
rope and if damaged, to replace it. This operation should be performed by an authorized person.
ASH DRAWER
From time to time you should open the drawer and empty it. This operation is performed depending on the
spent pellets and the quantity of ash.
BURNER
Clean the ash in the burner using a special vacuum cleaner. This operation should be performed
once a day
.
Only when the burner is clean, the proper operation of the pellet stove is guaranteed. If, during the operation
of the pellet stove, besides the pellets, there is sawdust, you should immediately clean the reservoir
.
Downloaded from
www.Manualslib.com
manuals search engine
