Installation and User Manual. Version V03.B03_EN (23/09/2015)
ecoGEO
6
ECOFOREST Geotermia
Direct exposure of the refrigerant to flames produces toxic gas. However, this gas can be detected
by its smell in concentrations well below the allowable limit. If you detect an unusual smell, evacuate
and ventilate the area until you are sure that the gas has been fully eliminated.
In the event of accidental refrigerant leakage, ventilate the area immediately.
Anyone who has had contact with the refrigerant vapour should evacuate the area immediately and
breathe fresh air.
FLAMMABILITY
Under normal conditions, there is no risk of explosion or combustion of the refrigerant contained in the
circuit.
SERVICING AND SCRAPPING
In order to repair the refrigerant circuit, the coolant contained within should not be released to the
atmosphere, but it should be recovered and destroyed in treatment plants intended for such purpose.
Considering the fact that the R410A is a mixture, in the event of leakage, the extra refrigerant should be
filled in liquid state. Filling the refrigerant in gaseous state alters its composition and might cause heat
pump malfunctions.
Before dismantling the heat pump, the coolant should be recovered for disposal at a treatment plant, in
accordance with the current regulations.
2.2. HYDRAULIC CIRCUITS
The installation and any further actions on the heating-cooling, brine and DHW circuits should be performed
by authorized personnel only and in accordance with applicable local regulations and following the
instructions provided in this manual.
DANGER!
Avoid touching the pipes, the compressor or other parts of the heating-cooling, brine and DHW
circuits during or immediately after operating the heat pump. These could be at high or low
temperature, and touching them could result in burns from heat or cold. If you need to touch these
parts, allow time for temperatures to stabilize and use protective gloves to prevent injuries.
