Installation and User Manual. Version V03.B03_EN (23/09/2015)
ecoGEO
38
ECOFOREST Geotermia
Relay OPEN: summer program.
Relay CLOSED: Winter program.
MENU 2.2.4.4. BMS CONFIGURATION
This allows setting the communication data parameters of the port of the micro-controller where
the indoor th-Tune terminal is connected (BMS port). To use the th-Tune terminals, it is
necessary to use the default configuration, which is shown in Figure 4.4.
Figure 4.4.
Default configuration of the BMS port for the correct operation of the th-Tune indoor
terminals.
MENU 2.2.5. PROTECTIONS
MENU 2.2.5.1. POWER LIMITATION
This allows adjusting the maximum thermal power given by the heat pump, which is established
by limiting the maximum rotation speed of the compressor.
In section 12.6 there are illustrations with the relations of the thermal power provided by the
different heat pump models as a function of the rotation speed of the compressor for the different
operation conditions. Furthermore, in section 12.7, there are illustrations with the relations of the
electrical consumption of the different heat pump models as a function of the rotation speed of
the compressor for the different operation conditions.
MENU 2.2.5.2. BRINE ALARM
It allows adjusting the value under which the alarm is activated due to low temperature in the
brine system.
MENU 2.2.5.3. PRESSURE BRINE/HEATING
This allows adjusting the values under which the alarm are activated due to low pressure in the
brine and heating-cooling circuits.
MENU 2.2.5.4. COOLING OUTLET TEMPERATURE
This menu is available only in the models ecoGEO B3. This allows adjusting the value under
which the alarm is activated due to low outlet temperature in ACTIVE COOLING mode.
MENU 2.2.5.5. PUMP PROTECTIONS
This allows seting the maximum and minimum speed of the circulation pumps (brine pump and
heating/cooling pump).
