USER MANUAL
– PROCAM HD 3D
Page
12
of
15
INMANUUIN136 Rev.2019.04.01 / ENG
Wait at least 15 minutes after cleaning the device before connecting it and using it
again.
6.2 FUSE REPLACEMENT
To avoid wasting time due to unavailability it is recommended to have spare fuses:
1) Disconnect the power cord from the power supply and equipment.
2) Below the power input at the rear side of the unit, there is a small rectangular piece of
plastic where the fuses are placed. With the help of a screwdriver and performing light
pressure, remove the cover to replace the damaged fuse..
3) Remove the damaged fuses and replace them immediately, use fuses of the same
characteristics as the replaced one..
Use ONLY fuses as indicated on the rear panel of the equipment and IEC60127
certification.
4) Place the plastic part containing the fuses again.
5) Connect the power cord.
7. TECHNICAL SPECIFICATIONS
POWER SUPPLY
110 - 240 V~
Nº OF PHASES
1 (single-phase)
FREQUENCY
50 - 60 Hz
CLASS
I
MODE
Continuous
GRADE OF WATER PROTECTION
IPX0
POWER CONSUMPTION
60 VA
FUSES
2 x T3AL250V
