USER MANUAL
– PROCAM HD 3D
Page
4
of
15
INMANUUIN136 Rev.2019.04.01 / ENG
Unplug the equipment when it is not being used.
This equipment has to be connected to ground through a ground conductor in the power
cable. This ground connection is essential for the safe use of the equipment.
The device is provided with a connectable power cable that assures proper electrical
isolation. If it needs to be replaced, the replacement shall not be longer that the original
cable and it needs to be certified under IEC 60245-1 or IEC 60227-1.
In case of interference with other electro medical or electric equipment, we recommend
increasing the distance between 3D Splitter and the other equipment to minimize these
effects.
Do not open the equipment. Maintenance and repairs must be done by ECLERIS or an
authorized company. ECLERIS will not be responsible for the consequences of repairs or
maintenance carried out by non-authorized personal.
In case of any problem, disconnect the power cable.
The device must be used only by personnel informed of all these warnings.
This instruction manual must be kept together with the equipment for future reference. If
the equipment is sold or donated this manual must be enclosed.
Any use outside of the manufacturer specific intent use, will exclude ECLERIS of all
liability.
If by any of the following:
Inadequate use of the equipment.
Failure to use the instruction manual.
Bad maintenance and care of the equipment.
Repair or manipulation by unauthorized personnel.
…personal or material damage is produced to a third party, ECLERIS, the manufacturer and
sales agent of this equipment, will not assume any responsibility for said damage.
The device should never be discarded with the household waste. Please check local
regulations for elect
ronic components disposal or recycling. It is the user’s responsibility
to deliver the system to the proper location for disposal or recycle of electrical and
electronic devices.
3. INTRODUCTION
The device is designed to capture the direct image of a microscope / colposcope with binocular
stereoscopic vision, these images are processed in the beam splitter where you can select
different levels of Gain / Brightness, Windows and perform White Balance.
The beam splitter has 2 removable adapters that allow you to install it in different models and
brands of microscopes / colposcopes available in the market. We recommend consulting for each
particular case informing brand and model.
In its conventional use the beam splitter is inserted between the head of the microscope and the
binocular, allowing the normal use of the binocular for a direct view with the microscope and/or
using a 3D glass which allows seeing 3D images on a 3D monitor screen.
The beam splitter connects directly to the main unit. The main unit has 3D-HD and 2D-HD video
outputs (HDMI).
