USER MANUAL
– PROCAM HD 3D
Page
7
of
15
INMANUUIN136 Rev.2019.04.01 / ENG
4. INSTALLATION AND SET UP
The connection and revision of the equipment must be carried out by technical personnel
with knowledge of the electrical installation from where the equipment will be powered.
1) Carefully unpack the equipment.
2) If you have an ECLERIS microscope or colposcope, you can attach the 3D main unit
directly to the forearm of the scope below the ECLERIS light source hanging from it. For
doing so using an Allen key, unscrew the two screws at the bottom of the 3D main unit as
shown in the picture. Two heads of screws will emerge from the top of the 3D main unit.
These heads of screws shall be anchored to the bottom side of the light source. The base
of the light source has two holes where the head of the screws of the Ecleris 3D main unit
shall be introduced. Once the head of the anchor screws are in place, you will need to
slightly push back the 3D main unit in order to attach it completely to the light source.
Finally to ensure a strong and stable coupling, tighten the screws of the 3D main unit from
the base of it
In case you have another brand/model of microscope or colposcope or if you prefer to use
the 3D main unit as a standalone one, you can lay the unit on a flat surface. If this surface
is far away from the beam splitter and the scope, you can order an extension cable (4
meters).
3) Connect the power cord to the wall socket or to the power input on the rear side of the
Ecleris light source.
4) Connect the 3D beam splitter cable to the front panel of the 3D main unit.
