50
Chapter 4
•
Installation instructions
3500782-0001 Revision E
The pole is shipped attached to the base bracket. Mount the base bracket of this
assembly to the structure with the appropriate hardware (not included). Consult
local building codes if needed. Once the base bracket is mounted, perform the
following steps (refer to
1.
Insert the bubble level into the end of the pole (pipe) opposite the base
bracket. The bubble level fits inside the pole.
2.
Loosen the pole attachment fasteners at the base bracket so the pole can
swivel.
3.
Swivel the pole until the end of the pole where the ODU will be installed is
vertical. Adjust the pipe position until the bubble is centered inside the
circles on the top surface of the bubble level.
4.
Tighten the pole attachment fasteners on the base bracket.
Figure 28: Base bracket and bubble level
Figure 29: Pole assembly
