GETTING STARTED
WITH THE
EBS RETRACER
8
USER GUIDE
7.
SELECT ENGINE
Hold down
A
and press
B
. You will now enter
SELECT ENGINE
menu. Use the
B
and
A
switches to change engine and
TAP/SET
to
load selected engine or escape the SELECT ENGINE menu with
ACTIVE
.
NOTE: When a new engine is loaded, it will always start with the setting
parameters that you have made in the [DEFAULTS] menu under the
global SETTINGS MENU (see bullet 5).
8.
HOLD DELAY MODE
Press and hold
TAP/SET
to activate
Hold Delay (H)
mode:
a)
TAP/SET
foot switch now holds the delay effect until you release
your foot from it (in default setting, you can change to toggle
deactivation in settings, if prefered).
b) Push
ACTIVE
once to cancel
Hold Delay
mode.
9.
“PANIC KILL” OF EFFECTS
Press and hold down
ACTIVE
until
PANIC
appears on screen in
order to “panic kill” the Retracer effects. This is useful if an engine
goes into stall because of excessive feedback.
EXTENDED EDITING IN EXPERT MODE:
10.
CHANGE TO EXPERT MODE
The Expert mode unlocks all features available in the Retracer.
Enter the [SETTINGS]
menu (as described above under bullet 5)
Select GENERAL menu, locate EXPERT and change the value OFF
to ON. Press
TAP/SET
to save and exit. The pedal now operates in
EXPERT MODE.
IMPORTANT!
In Expert Mode
B
and
A
gives access to the
parameter layers
connected to each individual engine instead
of offering navigation between presets. Values can be changed
with the four knobs. Indicators on the screen show what value is
attached to each knob in the layer.
11.
ACCESS PROGRAM SETTINGS MENU
After the last parameter layer for an engine, repeat pressing
B
to
access the PROGRAM SETTINGS attached to your current preset
(se reference on next page). When the name of the engine appears
within a pair of clamps you can use
LEVEL
to scroll down the list and
DELAY
to change the values in the right column.
7A9.
10A12.
[
GENERAL
]
EXPERT ON
TIME
MS/S
TAP
PROG
