Eaton XP-504, Manual, Page: 28 / 98

2. Safety regulations
2.3 Device-specific hazards
CAUTION
POINTY, SHARP OBJECTS AND CORROSIVE LIQUIDS
When cleaning the XP-504:
l
Do not use any pointy or sharp objects (e.g., knives).
l
Do not use aggressive or abrasive cleaning products or solvents.
Make sure that no liquids get into the XP-504 unit (short-circuit haz-
ard) and that the XP-504 unit is not damaged in any way.
CAUTION
INSTALLATION CUT-OUT
The mounting cutout must be located in a position that will not defeat
the purpose of stabilizing webs or other reinforcing elements in the
control panel. If necessary, reinforcing elements must be installed/ad-
ded.
An IP65 degree of protection will only be ensured if there is sufficient
stiffness and the device is properly mounted.
l
Minimum sheet thickness of control cabinet where the device will
be flush mounted:
1.5 mm (0.06“) ≦ d ≦ 4 mm (0.16“)
l
In order for the device to be properly mounted, every single one of
the holding brackets must be used at its intended spot.
CAUTION
When using commercially available peripheral devices (e.g., with the
USB port), it is important to keep in mind that their EMC interference
immunity parameters may render them unsuitable for use in industrial
environments.
The USB ports (USB host and USB device) on the computer core are
intended exclusively for maintenance work.
29
XP-504 08/2021 MN048028EN Eaton.com