76
8 Operating
Mounting and Operating Instructions CEAG Central Battery System ZB-S 40071860179 (L) November 2018 www.ceag.de
Displaying
O
O
Time and date (line 0)
O
O
Operating mode (line 1)
O
O
present voltage and current
value (line 2)
O
O
Fault information (line 3)
O
O
Status of mains supply at control
unit (line 4)
O
O
Device name (line 5)
Keypad
ESC key <ESC>
Menu key
ok key <ok>
and cursor keys
Memory card for saving and data
transmission of test log and parame-
ter settings
Control module
CU CG-S
1
Test & status menu
1.1
Start functiontest
1.2
Start durationtest
1.3
Cancel durationtest
1.4
Sum failure info
1.5
Circuit state
1.6
Luminaire state
1.7
DLS/TLS/3PhW state
1.8
Charging/Bat. state
1.9
Relay state
1.10
Substation state
Main menu
Main screen (Example)
1.
Test & status menu
2.
Block & reset alarms
3.
Basic settings
4.
DLS/TLS setup
5.
Circuit setup
6.
Luminaire setup
7.
Logbooksetup
8.
Send ServicePinMsg
MULTI-MASTER MODE M3:
In Multi-Master Mode the following func-
tions are possible to activate:
O
O
Start FT
O
O
Start/cancel DT
O
O
Substation-status (display)
O
O
Block/release device
O
O
Date/Time (set)
O
O
Automatic FT (specify)
O
O
Automatic DT (specify)
Previously, the substation needs to be
found in the menu «Main settings /
Substation setup».
Before the execution of the command
there is a request in the Mulit Master
Mode if this system-no. or all systems of
one group should execute this command.
The M3 function can only be executed
when all control units are interconnected
over the CG-S bus and no CGVision or a
CG controller is used.
O
O
Operation is the same for ZB-S
systems and for their US-S
substations.
O
O
If password protection is activated,
then only the main screen and the
main menu options “1 Test and
Status Menu” and “2 Block, Reset”
are accessible without entering a
password.
O
O
The controller software automatically
returns to the main screen if no entry
is made within 180 seconds.
O
O
The LCD display backlighting goes
off if no entry is made within 180
seconds. Pressing any key switches
the backlighting on again.
O
O
The contrast and brightness (LCD
backlighting) can be adjusted in the
main screen when the <ok> key is
pressed:
<ok> +
/
: contrast adjustment
<ok> +
/
: brightness adjustment
These parameters can also be set with
menu option “3.10 Display Setting” in
menu “3 Basic Settings”.
Here the parameters can be numerically
set as percentages.
