Transmission appearance may differ, procedure is the same.
21
Front Section
Mainshaft Assembly
How to Assemble the Mainshaft Assembly
17.
Position 1st speed gear spacer against 1st speed
gear, engaging the spacer external splines with
gear clutching teeth.
18.
With washer flat side down, position the limit
washer against the spacer. Rotate the washer until
the washer splines and mainshaft splines align.
19.
Push the air line up to lock the washer on the
mainshaft.
20.
Insert two large screwdrivers between 1st and 2nd
speed gears and apply light pressure. Between
the gear hub and mainshaft spacer, insert .006"
feeler gauge and .015" feeler gauge. If out of
tolerance, change the limit against the mainshaft
spacer. See ‘Special Instructions’ for further
information.
21.
Align the sliding clutch missing internal spline
with the mainshaft key and install the 1st-Reverse
speed sliding clutch.
22.
With the flat side up, position the Reverse speed
gear limit washer (white) in the next available
groove. Rotate the washer until the washer spIines
and mainshaft splines align.
23.
Push the air line up to lock the washer on the
mainshaft.
24.
Against the limit washer, position reverse speed
gear spacer.
continued
B/23-8
B/23-9
B/24-2
17
18
19
continued on next page
21
22
24
23
20
