Transmission appearance may differ, procedure is the same.
15
Auxiliary Section
Output Shaft Assembly
How to Assemble the Output Shaft Assembly
11.
With the auxiliary housing rear up, set the housing
over the output shaft.
12.
With tapered side down, use heat or appropriate
driver and install the output shaft rear bearing.
13.
Position a new gasket on the rear bearing cover
mounting surface, making sure the gasket oil
return holes align with the case oil return holes.
14.
If previously removed, use an oil seal installation
tool and install the oil seal in the rear bearing
cover.
15.
Position the rear bearing cover over the new
gasket.
16.
Apply Eaton/Fuller Sealant #71205 or equivalent
to the retaining capscrews.
17.
On AT/ATR/ATS models, use a new nylon collar
and brass washer at the chamfered hole, the hole
that intersects the speedometer bore.
18.
Install the retaining capscrews, tighten to 35-45
Lb
f
·ft of torque.
Final Check
Make sure the rear bearing is seated.
Make sure the rear bearing capscrews are properly
torqued.
Make sure the output shaft rotates freely.
S/35-8
A/09-8
V/08-1
A/10-3
continued
12
13
11
15
18
17
14
10
