SM65 Supervisory Module Handbook
48
Copyright © 2004-2009 Eaton Corporation. All Rights Reserved.
IPN 997-00012-35E December 2009
Step 9 - Push in the SM65, until it latches closed and tighten the locking screw
•
Keep fingers clear to avoid injury, as shown.
Step 10 - Reset any LVD controllers to Auto
If any LVD controllers were set to
Manual Connect
in Step 1 then reset them to
Auto.
Refer to the DC power system Installation Guide for information on how to set
the LVD Auto/Manual selector switch.
Procedure complete
Replacing the Real-time Clock Battery
•
Only service personnel should replace the real-time clock battery.
•
There is a risk of explosion if the used battery is replaced by an incorrect type.
•
Dispose of the used battery according to the battery manufacturer's instructions.
A 3.6V lithium battery provides power to the real-time clock when the SM65 is not powered
from a DC power system. The real-time clock battery may need to be replaced because of its
life span (approximately 11 years).
The battery can be replaced with a Tadiran TL-5902/s, or equivalent, ½ AA non-rechargeable
lithium battery.
