Communications
Copyright © 2004-2009 Eaton Corporation. All Rights Reserved.
IPN 997-00012-35E December 2009
31
GSM Modem (Requires SM65 v4 or later)
"
SM65 supervisory module
#
PC/laptop with
PowerManagerII and/or
DCTools. See setup details on
page
.
$
RS232 modem cable
(straight-thru)
%
SM30 modem cable (P/N
410-05225-80B)
!
GSM modem
&
Modem
3
SMS text capable GSM cell
phone
4
SMS text message "p"
5
Power status text messages
'
Alarm text messages
For implementation details see Setting up SMS Text Messaging on page
and Application
Note AN0024. To receive application notes refer to Worldwide Support on page
.
Modem connections allow dial-in from DCTools/PowerManagerII. Dial-out on alarm is only
available with SM65 v4 software or later. See Viewing Software Version on page
Setting up Modem Communications
For communications to PowerManagerII use a GSM (cellular) or PSTN (fixed line) modem.
Refer to Communications Options on page
Not all modems are suitable. If your modem does not operate correctly check the modem setup
string. Contact Eaton for further assistance. Refer to Worldwide Support on page
►
To enable modem communications
1
Connect to the SM65 with
DCTools
(refer to Communications Options on page
).
2
Go to
Configuration
>
Communications.
3
Click on
C
to expand
Modem
.
4
Set
Enable Modem
to
Enabled
.
5
If the SM65 is to report alarms to PowerManagerII then set
Alarm Report
to
Enabled
.
Requires SM65 with v4 software or later. See Viewing Software Version on page
6
Enter the telephone numbers the SM65 is to dial when an alarm is active.
The SM65 will first dial number 1. If the call fails it will try again after
Modem Retry
Interval
for the number of times set by
Modem Maximum Retries
. If the retries fail the
SM65 will try the next number on the list, and repeat for all numbers.
