Eaton Network-M2, User Manual

Page: 169 / 268

Checking the current firmware version of the Network Module
Servicing the Network Management Module – 169
•
•
•
•
•
This will allow to restart sequentially the IT equipment on utility recovery.
4.3.3.2.2 Resulting setup
UPS provides outlets (Group 1 and Group 2) and a primary output.
Connections to UPS can be done as described below:
Group 1: Applications
Group 2: Database servers
Primary: Storage
4.3.3.3 Step 2: Power outage policy settings
4.3.3.3.1 Objective
Use load segment restart settings to define restart sequencing.
4.3.3.3.2 Resulting setup
1. Navigate to Contextual help>>>Protection>>>Shutdown on power outage page and to the When utility comes back section.
2. Enable the "Keep shutdown sequence running until the end and then restart (forced reboot)".
3. Enable the "Automatically restart the UPS when battery capacity exceeds" and set it to 0%.
The storage will restart first, right after utility recovery without waiting the battery capacity to exceed a % limit.
4. Set Then Group 1 after to 120s.
The database servers will restart 120s after the utility recovery.
5. Set Then Group 2 after to 60s.
The database servers will restart 180s after the utility recovery.
4.4 Checking the current firmware version of the Network Module
Current firmware of the Network Module can be accessed in :
The Card menu : Contextual help>>>Maintenance>>>System information>>>Firmware information : Firmware version x.xx.x
The Card menu : Contextual help>>>Maintenance>>>Firmware : Active FW version x.xx.x
4.5 Accessing to the latest Network Module firmware/driver/script
Download the latest Eaton Network Module firmware, driver or script from the Eaton website www.eaton.com/downloads
When utility recovers, primary starts immediately.