Getting Started
Page 23
Transferring to another keypad
While in the Installer menu, you can transfer to any other keypad without leaving the
Installer menu. To do this, simply go to any other keypad and enter the Installer access
code. The new keypad will pick up your position in the Installer menu. The keypad you
have left will exit the Installer menu.
Using Downloader or the web interface
This manual describes configuring the control unit from a keypad. You can also program a
control unit using either of the following:
The web interface, through a web browser. Internet Explorer 11, Google Chrome
and Mozilla Firefox are supported. The i-on Web Browser Interface Setup Guide
explains how to configure the system using the web interface.
The Downloader software running on a PC. This can connect control unit via an
i-dig02 module (over PSTN), USB port or Ethernet port. Downloader is available to
registered users through
The settings and options provided through the web interface or Downloader have the
same behaviour as those provided through the keypad.
Before you can use the web interface or Downloader, the Master User must enable remote
access using
U
ser
Menu
– System Config – Facilities On/Off – Remote Access
. If remote
access is denied, the Master User can still start a call out to Downloader.
Exiting the Installer menu
To exit the Installer menu:
1.
Replace the lid of the control unit or other devices (if you removed them) to close all
tamper switches.
2.
Press
until the display shows:
3.
Press
to leave Installer menu. (Press
if you do not want to leave the menu.)
Note:
You must rectify faults (for example, the lid of the control unit is open) or delete
the device from the system before you can leave the Installer menu.
The control unit performs an automatic bus scan when you exit the Installer menu to
detect duplicate bus addresses, or lost/found devices (see page 51).
On completion, the display shows the time and date, and the system is ready for use.
