Test Menu
Page 104
If you selected Fast Format in
Report Type
, you can use
Fast Fmt Channels
to allocate an
event to each of eight channels. Table 12 shows the default events for each channel.
Table 13 and Table 14 show the events available. You can key-in the two-digit numbers
shown next to each event in order to display that event type on the keypad.
Table 12: Fast Format Channel Factory Defaults
Channel
Event
Channel 1
Fire Alarm
Channel 2
Hold Up Alarm
Channel 3
Burglar Alarm
Channel 4
Open/Close
Channel 5
Zone Omit (System)
Channel 6
Tamper
Channel 7
Confirmed Alarm
Channel 8
General Fault
Table 13: Fast Format Events (UK Systems)
00. Not used
12. Tamper (see note 6)
01. Fire Alarm
13. Open (see note 1)
02. Hold Up Alarm
14. Close (see note 1)
03. Burglar Alarm
15. Zone Omit (Setting) (see note 2)
04. Open/Close
16. Zone Omit (System)
05. Alarm Abort
17. General Fault
06. Technical Alarm
18. Masking
07. Confirmed Alarm
19. Zone Shunt
08. RF Low Battery
20. Duress Code
09. RF Supervision (see note 4)
21. HUA Confirm
10. RF Jamming (see note 4)
22. Burg Confirm Alarm
11. Mains Fail (see note 5)
23. Perimeter Alarm
24. Burg Alarm P1 (partitioned system only)
.. up to the maximum number of partitions
Table 14: Fast Format Events (EU Control Units)
00. Not used
12. Tamper (see note 6)
01. Fire Alarm
13. Open (see note 1)
02. Hold Up Alarm
14. Close (see note 1)
03. Burglar Alarm
15. Zone Omit (Setting) (see note 2)
04. Open/Close
16. Zone Omit (System)
05. Alarm Abort
17. General Fault
06. Technical Alarm
18. Masking
07. Confirmed Alarm
19. Zone Shunt
08. RF Low Battery
20. Duress Code
09. RF Supervision (see note 4)
21. Perimeter Alarm
10. RF Jamming (see note 4)
22. Burg Alarm P1 (partitioned system only)
11. Mains Fail (see note 5)
.. up to the maximum number of partitions
