Test Menu
Page 113
Using the
Triggers
option, you link each Message 1-4 with a specific event category you
wish to report. You then select a set of destinations for each message. Each destination
specifies one of the telephone numbers you wish the control unit to call when the event
occurs.
Call Mode
This option allows you to enable or disable SMS reporting.
Messages
Specify the text for the Home Message and for the additional four messages (Message 1-
4). The Home Message can have up to 12 characters. Message 1-4 can have up to 30
characters.
Triggers
For each Message 1-4, specify the event categories that you want to associate with the
message. You can choose one or more of the following:
Alarms
Includes all types of alarm, including 24 hour, Fire, HUA, Burg, test zone fail, Zone
Alarm and Zone Follow. This also includes restores from those alarms. See page 61
for details of how Zone Alarm and Zone Follow are configured.
Tampers
Includes all types of tampers, including system, keypad, expander, sensor, user code
(excess digits), siren, WAM and radio keypad.
Sets/Unsets
Includes any type of setting, part-setting or unsetting of a partition (or part set) by
either keypad, remote control, or keyswitch.
System
Includes any type of system event that is not an alarm, tamper or set/unset. This
includes bus device missing, jamming, supervision fail, communications failure or
fault, AC lost, low or missing system battery, low battery on radio device and Aux 12V
fail.
Destinations
Use this option to specify the recipients of the reports:
1.
Select a Message 1-4.
2.
Select one of the four recipients. Each Message 1-4 can have up to four recipients.
3.
Select a contact from the Contacts List (page 102), then one of the two telephone
numbers defined for that contact.
4.
If required, repeat the process from step 2 to specify additional recipients for the
message.
5.
If required, repeat the process from step 1 for another Message 1-4.
Incoming
If the control unit uses an i-gsm02 plug-in module, users can change or query the status of
the control unit using commands contained within SMS text messages sent from a mobile
phone or other messaging device. This feature can, for example, be used to set/unset the
system, activate/deactivate outputs, omit/un-omit zones or query the current status of the
system. For full details of the commands, please refer to the SMS Command Messaging
User's Guide.
