10
GridAdvisor™ Series II smart sensor installation instructions
IL915001EN
April 2019
Eaton.com
Regulatory information
Regulatory information
3G sensor compliance information
GridAdvisor Model: E0013X41G10
Contains FCCID: QIPPXS8 and QOQWT12
Contains IC: 7830A-PXS8 and 5123A-BGTWT12A
4G LTE sensor compliance information
GridAdvisor Model: E0013X41G12
Contains FCCID: XMR201707BG96 and QOQWT12
Contains IC: 10224A-201709BG96 and 5123A-BGTWT12A
Federal Communications Commission (FCC)
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 and
24 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and
receiver.
•
Connect the equipment into an outlet or circuit different
from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for
help.
Industry Canada:
This Class B digital apparatus meets all requirements of the
Canadian Interference Causing Equipment Regulations.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
Anatel
Anatel homologation: 3670-15-8433, (01)07898994273486
GridAdvisor Model: E0013X41G10
Este equipamento opera em caráter secundário, isto é, não
tem direito a proteção contra interferência prejudicial,
mesmo de estações do mesmo tipo, e não pode causar
interferência a sistemas operando em caráter primário.
This equipment operates on a secondary basis and,
consequently, is not entitled to protection against harmful
interference, even stations of the same type and may not
cause interference to systems operating on a primary basis.
Radio frequency (RF) exposure
In accordance with FCC requirements of human exposure to
radio frequency fields, the radiating element shall be installed
such that a minimum separation distance of 20 cm is
maintained.
Important battery information
•
Do not disassemble or open crush, bend or deform,
puncture or shred
•
Do not modify or remanufacture, attempt to insert foreign
objects into the battery, immerse or expose to water or
other liquids, expose to fire, explosion or other hazard.
•
Only use the battery for the system for which it is specified
•
Only use the battery with a charging system that has been
qualified with the system per this standard. Use of an
unqualified battery or charger may present a risk of fire,
explosion, leakage, or other hazard.
•
Do not short circuit a battery or allow metallic conductive
objects to contact battery terminals.
•
Replace the battery only with another battery that has been
qualified with the system per this standard, IEEE Std
1725™-2006 standard. Use of an unqualified battery may
present a risk of fire, explosion, leakage or other hazard.
•
Promptly dispose of used batteries in accordance with local
regulations
•
Battery usage by children should be supervised.
•
Avoid dropping the sensor or battery. If the sensor or
battery is dropped, especially on a hard surface, and the
user suspects damage, take it to a service center for
inspection.
•
Improper battery use may result in a fire, explosion or other
hazard.
