33
GREEN MOTION DC 22 EV CHARGER INSTALLATION MANUAL
MN192004EN November 2022 www.eaton.com
00
Title
7.2.3 Closing the front door after configuration of online station
WARNING – Not closing and securing the front door after configuring the online station can lead
to electric shock hazards.
Please refer to Chapter 8.1 of this manual on how to close the Green Motion DC 22 EV charger housing.
7.3 How to start charging
To start the charging session, simply connect the appropriate charging cable to the car socket. Hold the RFID card in
front of the reader (if the charging station is equipped with a RFID reader).
If the card is recognized, the LED starts flashing blue and then it shows the charge level (battery state of charge). Refer
to the description in Chapter 7.4.
If the CHAdeMO plug is used, it is mandatory for the user to select the plug on the screen. Refer to the next section.
If the card is not authorized, the charging will not start and a red triangle is displayed on the charging station status
display. See Chapter 7.4.
If the charging cable is disconnected from the car and there is no power consumption within two minutes, the user is
automatically deauthenticated.
7.4 Indicators and user interfaces
The EV charger has four different indicator levels and user interfaces embedded, as shown in Chapter 3:
•
LED indicators.
•
Color touchscreen display.
•
Emergency stop button.
Step 3.
Connect to the modem/router. If a step-by-step configuration menu "Setup Wizard" appears, ignore it and go
directly to the menus described below.
Step 4.
Go to the Network> WAN menu.
Step 5.
Activate and edit the MOB1S1A1 network. If necessary, enter the APN and the PIN code of the SIM card
(APN: shared.m2m.ch).
Step 6.
Press Save & Apply.
Step 7.
Insert the SIM card in the SIM card slot on the modem/router.
