39
GREEN MOTION DC 22 EV CHARGER INSTALLATION MANUAL
MN192004EN November 2022 www.eaton.com
00
Title
8.3 Replace the SIM card
To replace the SIM card, proceed as follows:
Step 1.
Remove the existing SIM card from the card slot. See Chapter 7.1.2.
Step 2.
Insert the new SIM card into the card slot. See Chapter 7.1.2.
8.4 Cleaning or replacing filters
Follow the steps below to replace the filters:
Step 1.
Open the housing by removing the fixing screws as described in section 8.1.
Step 2.
It is possible now to replace the filters. The filters are located on both left and right sides of the units, behind
the air flow grid. Using a 2.5 mm hex key, remove the 2 screws attaching each filter cartridge to the unit. See
Figure 35.
Please make sure that the fans are turned off and that the EV charger is not in use during the maintenance
operation. Moving fans can be dangerous and cause finger injuries.
Please make sure the filters are checked on a yearly basis to ensure they are not obstructed and working
properly. In case of obstruction, filters need to be replaced as soon as possible. In case of obstruction, Eaton
recommends not to use the unit and wait for the replacement of the filters.
Please contact your Eaton service representative for the new filter reference using the email address
Before starting connection operations, make sure that the external AC-line main switch is disconnected, and circuit
breakers are open.
Figure 35. Location of the filter on the left side of the unit
Step 3.
Please screw the new filters behind the air flow grid.
Step 4.
Close the front door and restart the unit.
