Front Section
Front Section
87
EA174
888
896
157
EA126
19. Install the necessary shim pack thickness
to adjust the countershaft end play in the
countershaft rear bearing bore and next, install
the bearing cup.
Note:
Use the proper drive tool E024001 to
install the bearing cup (see “Mainshaft
and Countershaft Rear Bearing Cups –
Removal and Installation”).
20. Remove any remaining sealant material from
housing mounting surfaces.
21. Use either a proper tap or screw and remove any
remaining sealant material from housing threaded
holes.
22. Apply a
Eaton 680
sealant string of
approximately 1.5 mm (1/16 inch) of thickness to
the center of the front housing mounting surface.
Inner side
1.5 mm (1/16 inch)
thick
FSO-2105/3a
23. Install the intermediate housing on the front
housing.
Note:
If necessary, carefully hit the housing’s
capscrews area with a plastic hammer to
match the housings.
24. Apply
Eaton 677
sealant to threads of the
thirteen retaining capscrews that secure the
intermediate housing to the front housing and
install the capscrews, tightening by hand until
capscrews are snug. Next, tighten capscrews
crosswise to the proper torque.
Torque = 19-25 N.m (14-19 Lb.ft)
