Front Section
68
Shift Selector Bar Assembly
1. The shift selector block is assembled on the main
bar with two retaining roll pins and therefore can
only be installed on one side of this bar.
197
2. Install the shift selector block on the shift bar.
3. Align the selector block with the shift bar
matching the roll-pin holes and install the
retaining roll pins. Using tool E001045, push the
roll pin until it is flush with selector block hub.
Note:
Replace the roll pins with new ones.
576
4. Install the spring supporting washers on both
sides of the selector block.
580
5. Install springs and supporting bushings.
585
6. Install the retaining snap rings of the selector
block using the E017021 special device.
602
548
5th/reverse Yoke Bar Assembly
1. Make sure the shift block is properly positioned
regarding the notch at the yoke bar end and
install the shift block on the yoke bar. Notice that
the opposite bar end also has a notch, shifted
180° from the other, and a hole.
624