Front Section
Front Section
85
7. Install the 1st/2nd shift yoke in the respective
synchronizer sleeve groove.
615
8. Install the 1st/2nd yoke bar in its respective bar
bore. The bar notch must be at the lower side.
Note:
Be careful to keep the double shifting
interlock balls in place.
615
9. Align the shift yoke with the yoke bar matching
the roll pin holes and install the retaining roll pin
using a 4 mm diameter pin punch. The 1st/2nd
yoke bar notch should be aligned with the 3rd/4th
shift block groove, formerly installed.
615
10. Install the shift selector bar in the bar bore,
positioning the shortest arm of the selector
block between the 1st/2nd yoke bar notch and
the 3rd/4th shift block groove. The longest arm
must be ahead the reverse shifting interlocking
mechanism. To do that, rotate the interlocking
mechanism by hand while positioning the shift
selector bar.
Note:
Be careful to keep the double shifting
interlock balls in place.
607
11. Align the 5th/reverse yoke bar with its respective
bar bore, with the longest arm of the selector
block and with the reverse shifting interlock pin,
and install the yoke bar.
626