ExoCab34 outdoor cabinet
User and Installation Guide
©Eaton Corporation 2018. All rights reserved.
Revision 0.1
Page 7 of 35
CAUTION
Only qualified service personnel knowledgeable of batteries and the required precautions are allowed
to perform installation or service work on batteries. Keep unauthorized personnel away from the
batteries. Before you install or replace batteries, consider all the warnings, cautions, and notes
concerning appropriate handling. Do not disconnect the batteries when the UPS is in the Battery
mode.
Make sure that your replacement batteries are of the same number and type as the battery that was
originally installed in the UPS. See more accurate instructions on the UPS.
Before you connect or disconnect battery terminals, disconnect the charging source by opening the
corresponding battery circuit breaker.
Check if the battery is inadvertently grounded. If it is, remove the source of the ground. Contacting any
part of a grounded battery can cause a risk of electric shock. If you disconnect the grounding
connection before you work on the batteries, the risk of an electric shock is less likely.
Dispose of batteries according to your local disposal requirements.
Do not dispose of batteries in a fire. When exposed to flame, batteries may explode.
To ensure proper cooling airflow and to protect personnel from dangerous voltages inside the unit,
keep the UPS door closed and the front panels installed.
Do not install or operate the UPS system close to gas or electric heat sources.
Keep the operating environment within the parameters stated in this document.
Keep the surroundings of the UPS uncluttered, clean, and free from excess moisture.
Observe all DANGER, CAUTION, and WARNING notices affixed to the inside and outside of the
equipment.
