ExoCab34 outdoor cabinet
User and Installation Guide
©Eaton Corporation 2018. All rights reserved.
Revision 0.1
Page 19 of 35
Step 5 – Pour base
Refer to section 13 ‘
Appendix E Concrete plinth drawing
’? for Concrete Base
dimensions.
Step 6 - Install earth rod(s)
1
Check there are no cables or pipes below the cabinet base that may be
damaged by the earth rod(s).
2
If multiple earth rods used they must be the same material to prevent
electrolytic corrosion.
Procedure complete
5.3
Place cabinet
Step 1 - Lift and position cabinet
1
Check that the base is clean and the bolt-down sockets are free of debris.
2
Lift the cabinet (minus batteries) by the four lifting eyes on the top of the cabinet into
position.
Follow all applicable health and safety regulations.
Lifting
points
Step 3 - Bolt down cabinet
1
Remove the access panels in the cabinet plinth.
2
If on an existing concrete floor mark and drill holes.
3
Use the four M10 grade 12.7 galvanized bolts and washers supplied.
4
Re-fasten the plinth access panels to the cabinet.
Plinth access covers
Procedure complete
