C h a p t e r 2 : S o f t w a r e T o o l s , U t i l i t i e s a n d P r o g r a m s
3 7
Calibrating the Touchscreen
The PanelMate ePro PS units are always in Protect Mode. This means that new
calibration values will NOT be saved but will be in effect only until the unit is restarted. In
order to save new calibration values you must run the
you do not perform this step, the ePro PS will revert back to the last saved calibration
settings when restarted.
Refer to the
section for additional information.
Calibrating Display Models
PanelMate ePro PS units with 8”, 10”, 12” or 15” displays include a PenMount
touchscreen driver that loads automatically at startup. A
Calibrate Touchscreen
icon is
placed in the system tray in the lower-right corner (by the clock) of the display.
If for some reason you find it necessary to re-calibrate the touchscreen, you can do so
by selecting the icon. You can also select
Start>Programs>PenMount USB
Utilities>Touchscreen Control Panel
to launch the calibration program. Once the
calibration program is launched you will see the following
PenMount Control Panel
dialog box.
While in your normal operating position, select the
Standard Calibration
button on the
Calibrate
tab and then proceed to touch the red squares as directed. The squares will
appear at the top, right, bottom, left and central-area of the screen.
Note:
The red square at the bottom of the screen will not be visible but the arrow will be
partially drawn, this is normal operation. Select a point closest to the end of the arrow.