Eaton 93PM Integrated Accessory Cabinet-Distribution (50–200 kW) Installation and Operation Manual P-164000229—Rev 09
33
C
Chhaapptteerr 44 IInnssttaallllaattiioonn
44..11
P
Prreelliim
miinnaarryy IInnssttaallllaattiioonn IInnffoorrm
maattiioonn
WARNING
Installation should be performed only by qualified personnel.
Refer to the following while installing the Eaton 93PM Integrated Accessory Cabinet-Distribution (IAC-D):
•
See
Installation Plan and Unpacking
for cabinet dimensions, equipment weight, wiring and
terminal data, and installation notes.
•
Do not tilt the IAC-D more than 10° vertical or the cabinet may tip over.
44..22
U
Unnllooaaddiinngg tthhee IIA
AC
C--D
D C
Caabbiinneett ffrroom
m tthhee P
Paalllleett
DANGER
RISK OF INSTABILITY. Do not remove any internal panels until the cabinet is removed from and lowered from
the pallet.
WARNING
•
The IAC-D is heavy (see
).
•
Do not tilt the IAC-D more than 10° from vertical or the cabinet may tip over.
•
Lift the cabinets only with a forklift or pallet jack or damage may occur.
•
Ensure the forklift or pallet jack is rated to handle the weight of the cabinet.
Failure to follow these instructions may result in severe injury or death.
NOTE
Before performing the IAC-D unloading, verify that the forklift or pallet jack is rated to
handle the weight of the cabinet (see
for cabinet weight).
The IAC-D is bolted to a pallet consisting of two metal angle supports and two flat supports secured to two
wood supports.
1.
If not already accomplished, use a forklift or pallet jack to move the IAC-D to the installation area, or as
close as possible, before unloading from the pallet. Insert the forklift or pallet jack forks between the
supports on the bottom of the pallet (see
for the IAC-D cabinet center of gravity measurements).
2.
Open the front door (see
) by lifting the latch from the bottom and turning to the right
(counterclockwise) and swing the door open.
3.
Locate the four 1/2" jacking bolts from the parts bag packed inside the front door and install them in the
threaded holes in the front and rear supports as shown in
. Place a floor protector from the parts
kit underneath each jacking bolt, and screw the bolts down against them.
The floor protectors protect the floor from being marred by the jacking bolts.
4.
Loosen, but do not remove, the skid mounting bolts holding the left, right, front, rear, and two center
supports to the pallet skids (see
).
DO NOT
loosen or remove the cabinet mounting bolts or the
cabinet support bolts.
Summary of Contents for 93PM IAC-D
Page 108: ...P 16400022909 P 164000229 09...
