EASTMAN 3059, Modification Instructions

Page: 81 / 115

MODIFICATION INSTRUCTIONS, TYPE1
6 01MAY97 – 8B7489
[2] Remove the DRYER THERMISTOR and the DRYER OVER-TEMPERATURE THERMOSTAT from the
BRACKET(S).
[3] Disconnect the wires from the DRYER OVER-TEMPERATURE THERMOSTAT. Discard the
THERMOSTAT.
[4] Disconnect the DRYER THERMISTOR at the CONNECTOR. To free the wires, cut any TIE WRAPS
necessary Discard the THERMISTOR.
[5] Remove the DRYER BLOWER ASSEMBLY from the PROCESSOR.
(a) Remove the 3 SCREWS.
(b) Bend the BLOWER SLEEVE down to release the BLOWER ASSEMBLY from the PLENUM.
[6] From the nondrive side of the PROCESSOR, pull the wires for the DRYER OVER-TEMPERATURE and the
DRYER THERMISOR outside the TANK.
[7] Prepare the new wires. See the figure below.
(a) Cut the CONNECTOR from the new DRYER OVER-TEMPERATURE THERMOSTAT. Discard the
CONNECTOR.
(b) Remove approximately 4 cm (1
1
⁄
2
in.) of the OUTER CASING from around the wires.
(c) Remove approximately 5 mm (
1
⁄
4
in.) of the insulation from the wires.
(d) Do Steps (a), (b), and (c) for the DRYER THERMISOR.
[8] Install the new DRYER THERMISTOR and the DRYER OVER-TEMPERATURE THERMOSTAT to the
BRACKET(S). Use the SCREW(S) and WASHER(S) from Step 2 above.
[9] Route the wires for the new DRYER THERMISTOR and DRYER OVER-TEMPERATURE THERMOSTAT
from inside the TANK to outside.
[10] Install the BRACKET(S) on the TANK. Use the SCREW and WASHERS from Step 1 on Page 4.
Connecting the New DRYER OVER-TEMPERATURE THERMOSTAT
Note
Do the following steps outside the TANK, on the
nondrive side of the PROCESSOR.
[1] Prepare the existing wires.
(a) Cut approximately 28 cm (11 in.) from the
existing wires for the DRYER OVER-
TEMPERATURE THERMOSTAT.
(b) Remove approximately 4 cm (1
1
⁄
2
in.) of the
OUTER CASING from around the wires.
(c) Remove approximately 5 mm (
1
⁄
4
in.) of the
insulation from the wires.
[2] Connect the new wires to the existing wires.
(a) Twist the end of one of the existing wires
around the end of one of the wires coming
from the new DRYER OVER-
TEMPERATURE THERMOSTAT.
(b) Insert the twisted wire ends into one of the
CLOSED-END SPLICES from the Mod
Kit. Use TL-2020 (or the equivalent) to
close the SPLICE.
[3] Do Step 2 for the other wire.
[4] Move the wires to positions that will not have contact with moving parts or be compressed by the PANELS.
4 cm
(1 1/2 in.)
5 mm
(1/4 in.)
H104_0595AA
H104_0595ACA
SPLICE
CLOSED-END
wires
CASING
OUTER