Users manual
ET1260B and ET1260A
6 1/2 Digit Multimeter
22
difference between actual measurement value and current recorded value.
5) Press the softkey of Display (
) to switch modes, and refer to the chapter of
Users
interface
for details.
6) If necessary, press
to configure the following measurement parameter, that is gate time,
and refer to the chapter of
Measurement configuration
for details.
7) If necessary, press
to configure math operation function (limits and relative), and refer
to description in the chapter of
Math operation
for details.
2.1.8 Capacitance measurement
Basic information
Measurement range: 1nF, 10nF, 100nF, 1uF, 10uF, 100uF, 1mF, 10mF and 100mF.
Maximum resolution: 10pF.
Operation description
1) Press
to select capacitance measurement function.
2)
Description: Major displayed value refers to measurement capacitance value, and auxiliary
displayed value refers to the ratio between the measurement value and full measurement range.
3) Connect test lines as indicated in the chapter of
1.4 Measurement wiring
.
4) Select measurement range as required, and may select automatic measurement, or press the
softkeys of Measurement range+ (
) and Measurement range- (
) to select fixed
measurement range, which have same effect as keys of
and
.
5) Press the softkey of Relative (
) to record the current value, after which display the
difference between actual measurement value and current recorded value.
6) Press the softkey of Display (
) to switch modes, and refer to the chapter of
Users
interface
for details.
7) If necessary, press
to configure math operation function (limits and relative), and refer
to description in the chapter of
Math operation
for details.
Test leads capacitance eliminating method:
1. Plug out the probe end of positive lead out from test circuit, and keep it open.
2. Press
Relative
to make zero.
