Users manual
ET1260B and ET1260A
6 1/2 Digit Multimeter
20
2.1.6 Resistance measurement
Basic information
10Ω, 100Ω, 1kΩ, 10kΩ, 100kΩ, 1MΩ, 10MΩ, 100MΩ and 1GΩ.
Maximum resolution: 10uΩ.
Operation description
1) Press
to select 2-wire resistance measurement or 4-wire resistance measurement
function.
Description: Major displayed value refers to measurement voltage value, and auxiliary displayed
value refers to the ratio between the current measurement value and full measurement range.
2) Connect test lines as indicated in the chapter of
1.4 Measurement wiring
.
3) Select measurement range as required, and may select automatic measurement, or press the
softkeys of Measurement range+ (
) and Measurement range- (
) to select fixed
measurement range, which have same effect as keys of
and
.
4) Press the softkey of Relative (
) to record the current value, after which display the
difference between actual measurement value and current recorded value.
5) Press the softkey of Display (
) to switch modes, and refer to the chapter of
User
interface
for details.
6) If necessary, press
to configure the following measurement parameters: integral time
and zero calibration and refer to the chapter of
Measurement configuration
for details. Start
automatic zero calibration during 4-wire resistance measurement.
