Users manual
ET1260B and ET1260A
6 1/2 Digit Multimeter
11
1.4 Adjust Handles
To adjust handles of digit multimeter, please hold the handles on both sides of the meter, and
then rotate the handles to the needed positions. Operating method is as shown in the following
figure
Handles adjusting method
Position during working
Position during carriage
1.5 Start Multimeter
1. Connect to AC power
1) Power supply of multimeter may select 110V or 220V, and you may adjust power voltage
selector installed on multimeter rear panel according to your power supply voltage.
2) Connect the multimeter to AC power with power line supplied by accessories.
2. Start multimeter
Turn on the power switch under power outlet.
3. If the instrument is not normally started, please check according to the following steps:
1) Check whether power line is well connected.
2) Check whether the power switch of rear panel is turned on.
3) If the instrument still can not be started after check, please check whether the power fuse is
blown out, if necessary, replace fuses.
4) If the instrument still can not be started after check, please contact relevant departments.
