11
Now mount the U-shaped bracket. To do this, insert four lock screws M6 x 70 from the inside, through the frame of the rack table and, from the outside, place
the U-shaped bracket onto the screws. Secure the U-shaped bracket using washers and knurled nuts.
Knob nut M6
Washer 6 mm
Lock screw M6 x 70
U-shaped bracket
5.1.2 Mounting the U-shaped bracket
To mount the rear lights, first place these in the protective moulds. Make sure that the cable is fitted cleanly into the duct and is not crushed. The rear lights
with the reverse light is mounted on the right (in the direction of travel) and the fog light is mounted on the left, in doing so, the openings for license plate
illumination for both lights must be on the inside. Now insert the threaded bolts of the rear lights through the drilled holes in the rack table and screw into place
using washer and M5 nuts.
Protective mould left
Protective mould right
Washer 5 mm
Nut M5
reversing light
5.1.3 Mounting the rear lights
Rear light, left
Rear light, right
Mount the license plate holder using the already mounted screws and washers to the rack traverse in such a way that the lamps and the license plate holder are
level. The mounting clips for securing the license plate are push-out parts in the holder. Break out two of the clips. Slide the license plate into the holder, then
push the clips into the cut-outs to secure the license plate.
Cut-out for installation clips
Clips
5.1.4 Laying the electrical cables
Lay the cables alongside the pipe of the rack table. The cables may not be kinked, stretched nor squashed. Secure the cables with the supplied cable ties. When
you are finished, trim any excess material from the cable ties using cutting pliers.
5.1.6 Mounting the wheel stoppers
Now push a wheel stopper on from above onto each of the wheel rails. Make sure that the higher side of the wedge shape points towards the middle of the
rack. Insert a small tensioning strap through the middle opening of each of the stoppers and under the wheel rail on the opposite side, then back through the
middle opening.
5.1.5 Mounting the license plate holder/inserting the license plate
Tensioning strap 9x
Stopper 6x
