E-MORE 2M2S, Operation Manual

Page: 13 / 28

13
E-MORE 2M2S / 2M3S
Press the “S” key for 5 seconds to select between the different settings by using the UP or DOWN key. After you changed a
setting, you have to save the new setting by pressing the “S” key again.
S-1 Unit of measure Press “S” and then select: 0 for cm, 1 for inches
S-2 Gyroscope sensor Press “S” and then select: 0 = off, 1 = least sensitive to 8 = most sensitive
S-3 Anti-collision sensitivity moving up Press “S” and then select: 0 = off (not recommended), 1 = least sensitive to 8
= most sensitive
S-4 Anti-collision sensitivity moving down Press “S” and then select: 0 = off (not recommended), 1 = least sensitive to 8
= most sensitive
S-5 Display height Press “S” and then using the up / down keys you can change the display
height if necessary
S-6 frame operating mode Press “S” and then select: 0 = constant touch or 1 = one-touch
S-7 Duty cycle To deactivate the overheating protection – please do not change!
S-8 frame tilt sensitivity Press “S” and then select 0 = off, 1 = 0.5°, 2 = 1.0°, 3 = 1.5°, 4 = 2.0°, 5 = 2.5°, 6
= 3.0°, 7 = 3.5°, 8 = 4.0°
After adjusting all settings you have to press the “S” key again to return to the main menu.
Minimum /Maximum height
To select a minimum height do the following: Move the frame to the desired minimum height. Press the UP & Down key simul-
taneously for about 5 seconds. A beep indicates that the minimum height has been set. (IMPORTANT: You can only select a
minimum height that is below 92.6 cm)
To remove the minimum height please move the frame to the programmed minimum height, than press the Up & Down key
simultaneously until you hear a beep indicating that the minimum height was deleted.
To set/delete the maximum height please proceed the same way. The maximum height must be more than 92.7 cm.
HOW TO ADJUST SETTINGS BY USING THE HAND CONTROLSETS
TROUBLESHOOTING
Error Code Possible Cause How To Correct
E1, E6, E7 Power failure Reconnect power - switch power source
E2 Lifting columns out of synch Perform a reset as described under 1.
E4 Handset fault Unplug and plug in the cable of the handset
E5 Anti-collission warning standard function, no corrective action required
E8 Desktop not level Level the table
E11, E21 Motor fault Check the motor wire connections
E12, E22 Control box failure Control box needs to be replaced
E14 - E17 | E24 - E27 Motor failure Motor / lifting column needs to be replaced
E18, E28 Overload protection Reduce the weight
HOT
Excessive use Do not use for 20 minutes. System will recover automatically.