Rev. 4.0
38
[email protected] • www.e-breathe.de
e-breathe Smartblower
a) Ensure that the breathing hose has no cracks or holes and is completely intact. Also check the seals at the hose
connections. If the hose is not completely intact, do not use it.
b) Screw the round thread connection of the breathing air hose clockwise onto the yellow union nut of the motor unit.
Make sure that the hose does not twist.
c) Ensure that the breathing hose is securely and firmly connected to the blower to prevent the ingress of ambient air.
d) To remove the breathing hose, unscrew the round thread connection anti-clockwise from the yellow union nut.
4.2.3.3 Breathing Hose Assembly / Replacement
Read the instructions for use enclosed with the head piece carefully.
!
b)
Assembly Y-Connector & two particle filters
The Y-Connector is an adapter that allows the use of two particle filters for the e-breathe smartblower system. This can
prolong the operating time and increase the initial air flow of the blower with new particle filters.
Screw both particle filters clockwise and hand-tight into the Y-connector.
Fig. 13
Disassembly Y-Connector & two particle filters
For disassembly, screw the two particle filters out of the Y-connector counterclockwise.
c) Assembly Y-Connector & Motor Unit
Through the Y-connector and the particle filters attached to it, the motor unit sucks the air from the outside and
passes it filtered to the head part.
Place the motor unit with the connecting cable aligned to the right on the yellow union nut of the Y-connector. Hold
the motor unit tight to prevent the connecting cable from twisting and hand-tighten the yellow union nut of the Y-
Conncetor clockwise into the internal thread of the motor unit.
Figure 14
Disassembly Y-Connector & Motor Unit
Hold the motor unit firmly and unscrew the yellow union nut of the Y-Conncetor counterclockwise from the motor
unit.
d) Assembly Smartbelt & SVE
There is a loop on the Smartbelt to attach the SVE. Insert the clip on the SVE through the loop until the SVE is securely
attached.
Fig. 15
Disassembly Smartbelt & SVE
To remove the SVE from the smartbelt, pull the SVE out of the loop.
