EN
USING YOUR DYSON APPLIANCE
PLEASE READ THE 'IMPORTANT SAFETY INSTRUCTIONS' IN THIS DYSON
OPERATING MANUAL BEFORE PROCEEDING.
OPERATION
•
Do not use outdoors or on wet surfaces or to vacuum water or other liquids –
electric shock could occur.
•
Ensure the appliance remains upright in use and in storage. Dirt and debris may
be released if it is turned upside down.
•
Do not operate while checking for blockages.
•
For domestic indoor and car use only. Do not use it whilst the car is in motion or
while driving.
•
To operate the boost mode, hold the trigger down and press the boost button.
The boost button will light up.
•
To switch off boost mode, hold the trigger down and press the boost button
again. Note: The appliance will retain the last used mode. So if you use it in
boost mode and do not disengage it, the appliance will operate in boost mode
when it is next used until you depress the boost button to disengage it.
CARPETS OR HARD FLOORS
•
Before vacuuming your flooring, rugs and carpets, check the manufacturer's
recommended cleaning instructions.
•
The brush bar on the appliance can damage certain carpet types and floors.
Some carpets will fuzz if a rotating brush bar is used when vacuuming. If this
happens, we recommend vacuuming without the motorised floor tool and
consulting with your flooring manufacturer.
•
Before vacuuming highly polished floors, such as wood or lino, first check that
the underside of the floor tool and its brushes are free from foreign objects that
could cause marking.
LOOKING AFTER YOUR DYSON APPLIANCE
•
Do not carry out any maintenance or repair work other than that shown in this
Dyson Operating Manual, or advised by the Dyson Helpline.
•
Only use parts recommended by Dyson. If you do not this could invalidate
your guarantee.
•
Store the appliance indoors. Do not use or store it below 3°C (37.4°F). Ensure
the appliance is at room temperature before operating.
•
Clean the appliance only with a dry cloth. Do not use any lubricants, cleaning
agents, polishes or air fresheners on any part of the appliance.
VACUUMING
•
Do not use without the clear bin and filter in place.
•
Fine dirt such as flour should only be vacuumed in very small amounts.
•
Do not use the appliance to pick up sharp hard objects, small toys, pins, paper
clips, etc. They may damage the appliance.
•
When vacuuming, certain carpets may generate small static charges in the clear
bin. These are harmless and are not associated with the mains electricity supply.
To minimise any effect from this, do not put your hand or insert any object into
the clear bin unless you have first emptied it. Clean the clear bin with a damp
cloth only. (See ‘Cleaning the clear bin’.)
•
Use extra care when cleaning on stairs.
•
Do not rest the appliance on chairs, tables, etc.
•
Do not press down on the nozzle with excessive force when using the appliance
as this may cause damage.
•
Do not leave the cleaner head in one place on delicate floors.
•
On waxed floors the movement of the cleaner head may create an uneven
lustre. If this happens, wipe with a damp cloth, polish the area with wax, and
wait for it to dry.
DIAGNOSTICS - MAIN BODY
When in use, trigger pressed:
EMPTYING THE CLEAR BIN
•
Empty as soon as the dirt reaches the level of the MAX mark – do not overfill.
•
Ensure the appliance is disconnected from the charger before emptying the
clear bin. Be careful not to pull the 'ON' trigger.
•
To release the dirt, push the red button at the side of the clear bin as shown.
•
To minimise dust/allergen contact when emptying, encase the clear bin tightly in
a plastic bag and empty.
•
Remove the clear bin carefully from the bag.
•
Seal the bag tightly, dispose as normal.
•
Close the clear bin base so it clicks into place and is secure.
CLEANING THE CLEAR BIN
•
Ensure the appliance is disconnected from the charger before removing the
clear bin. Be careful not to pull the ‘ON’ trigger.
•
To remove the clear bin, push the red button at the side of the clear bin as you
would when emptying the clear bin. This will expose the red release button on
the underside of the handle. Press this to release the clear bin.
•
Remove the clear bin carefully.
•
Clean the clear bin with a damp cloth only.
•
Do not use detergents, polishes or air fresheners to clean the clear bin.
•
Do not put the clear bin in a dishwasher.
•
Clean the cyclone shroud with a cloth or dry brush to remove any lint and dust.
•
Ensure the clear bin is completely dry before replacing.
•
To replace the clear bin, fit the tab on the rim of the cyclone shroud into the
aperture on the inside of the top of the clear bin. Push the clean bin up and in. It
will click into place.
•
Close the clear bin base so it clicks into place and is secure.
WASHING YOUR FILTER
•
Ensure the appliance is disconnected from the charger before removing the
filter. Be careful not to pull the ‘ON’ trigger.
•
Your appliance has one washable filter, located as shown.
•
Press the blue ‘Filter’ button so you can remove the cyclone and clear bin unit.
•
Check and wash the filter regularly according to instructions to
maintain performance.
•
The filter may require more frequent washing if vacuuming fine dust or if used
mainly in ‘Powerful suction’ mode.
•
Wash with cold water only. Do not use detergents.
•
Do not put the filter in a dishwasher, washing machine, tumble dryer, oven,
microwave or near a naked flame.
•
IMPORTANT: After washing please leave at least 12 hours to dry completely
before refitting.
•
Place the dry filter into the recess of the handle.
•
Fit the base of the handle into the aperture on the base of the cyclone and clear
bin unit. Push both halves together until the ‘Filter’ button engages and locks
into place.
LOOKING FOR BLOCKAGES
•
Ensure the appliance is disconnected from the charger before looking for
blockages. Be careful not to pull the ‘ON’ trigger.
•
Do not operate while checking for blockages. Doing so could result in
personal injury.
•
Beware of sharp objects when checking for blockages.
•
If you cannot clear an obstruction you may need to remove the brush bar. Use
a coin to unlock the fastener marked with a padlock. Remove the obstruction.
Replace the brush bar and secure it by tightening the fastener. Ensure it is fixed
firmly before operating the appliance.
•
Refit all parts securely before using.
•
Clearing blockages is not covered by your guarantee.
BLOCKAGES – AUTOMATIC CUT-OUT
•
This appliance is fitted with an automatic cut-out.
•
If any part becomes blocked the appliance may automatically cut out.
•
This will happen after the motor pulses a number of times (i.e switches on and
off in quick succession).
•
Leave to cool down before looking for blockages.
•
Ensure the appliance is disconnected from the charger before looking for
blockages. Failure to do so could result in personal injury.
•
Clear any blockage before restarting.
•
Refit all parts securely before using.
•
Clearing blockages is not covered by your guarantee.
CHARGING AND STORING
•
This appliance will switch ‘OFF’ if the battery temperature is below 3°C
(37.4°F). This is designed to protect the motor and battery. Do not charge the
appliance and then move it to an area with a temperature below 3°C (37.4°F)
for storage purposes.
•
To help prolong battery life, avoid recharging immediately after a full discharge.
Allow to cool for a few minutes.
•
Avoid using the appliance with the battery flush to a surface. This will help it run
cooler and prolong battery run time and life.
DIAGNOSTICS – BATTERY
When charging battery:
BATTERY SAFETY INSTRUCTIONS
•
If the battery needs replacing please contact the Dyson Helpline.
•
Use only Dyson chargers for charging this Dyson appliance.
•
The battery is a sealed unit and under normal circumstances poses no safety
concerns. In the unlikely event that liquid leaks from the battery do not touch the
liquid and observe the following precautions:
– Skin contact – can cause irritation. Wash with soap and water.
– Inhalation – can cause respiratory irritation. Expose to fresh air and seek
medical advice.
– Eye contact – can cause irritation. Immediately flush eyes thoroughly with
water for at least 15 minutes. Seek medical attention.
– Disposal – wear gloves to handle the battery and dispose of immediately,
following local ordinances or regulations.
CAUTION
The battery used in this device may present a risk of fire or chemical burn if
mistreated. Do not disassemble, short contacts, heat above 60°C (140°F), or
incinerate. Keep away from children. Do not disassemble and do not dispose of
in fire.
DISPOSAL INFORMATION
•
Dyson products are made from high grade recyclable materials. Recycle
where possible.
•
The battery should be removed from the product before disposal.
•
Dispose of or recycle the battery in accordance with local ordinances
or regulations.
•
The battery is fixed by two screws: one is on the outside of the handle; the other
is on the lower part of the main body behind the filter. Remove these and take
off the battery.
•
Ensure the appliance is disconnected from the charger before removing the
battery. Be careful not to pull the ‘ON’ trigger.
Charging.
Fully charged.
Not charging – check battery.
Not charging – too cold/too hot.
Less than one minute of charge remaining/
fully discharged.
Too cold/too hot – do not use.
16
