Dynapac F1000W T4f, Operation & Maintenance Manual

Page: 179 / 275

D 4.0 14
Loading/distributing material
- Open the hopper with switch (15).
Have the truck back short of the paver and pull the paver against the truck tires.
Guide the truck driver when dumping the material mix.
- Set the switch (45) of the auger and conveyor to the “ON” position.
- Set both switches (46) of the auger and conveyor to “AUTO“ position.
- Set the appropriate auger switch on the remote control and conveyor switch (if ap-
plicable) to “auto“ position.
- Set the selector (21) for traction drive / engine to position 1 and push the drive lever (20) forward
(away from operator).
Conveyor and auger will begin to work.
The limit sensors for the conveyors and augers must switch off the function when the
material has reached the height limit in the area beneath the auger crossbeam (con-
veyor sensors) or at the auger ends (auger sensors).
Check that the material is being conveyed properly.
- If the material is not being conveyed properly, switch conveyor and auger to “MAN-
UAL“ by using switch (46) until a sufficient amount of material lies in front of the
screed.
- Switch conveyor and auger to “AUTO“ using switch (46).