Maintenance - Every 10 hours
2018-02-19
4812325557EN
75
Check the hydraulic oil level
1. Park the roller on a level ground and turn off the engine.
2. Check the hydraulic oil reservoir sight glass (1) located on
the right side of the machine.
3. If the oil level is 2 cm below the glass upper line, fill with the
recommended hydraulic oil.
Use only hydraulic oil recommended by
DYNAPAC.
Filling the fuel tank
Never fill the engine when it is working. Do not
smoke and avoid spilling fuel.
The filling nozzle and the tank cap are in the front of the operator
platform, in the left side of the machine.
Check the fuel tank daily before starting the operation or fuel
the tank when the work is done.
Unscrew the tank cap (1) and check up to the lower edge of the
filler pipe.
The tank capacity is of 58 gal (220 liters) of fuel. For further
information about the fuel grade, refer to the Engine Manual.
Before filling, stop the machine on a safe place
with level surface, turn off the engine and
ground the filling pipe, putting it in contact with
the frame in a non-insulated place.
When filling, keep the pump nozzle in contact
with the filling pipe. Always use fuel
recommended by DYNAPAC.
Using adulterated, contaminated, dirty or bad
quality fuel damages the injection system and
engine components.
The repairs due to the conditions above are NOT
covered by the warranty.
Fig. - Hydraulic oil reservoir
1. Oil sight glass
2. Filling plug
Fig.
– Fuel tank
1. Tank cap
2. Filling pipe
1
2
