Maintenance - Every 50 hours
2018-02-19
4812325557EN
83
Replace the hydraulic oil filters
The hydraulic filters are located on the left side of the engine
compartment, behind the battery disconnecter.
TAKE CARE OF THE ENVIRONMENT: All the
used oil shall be properly stored for
subsequent disposal. Do not dispose of oil on
the ground, sewage system or other place
which can harm the environment. The filter is
disposable and cannot be cleaned.
1. Open the hydraulic oil tank cap (1).
2. Clean carefully the sealed surface on the filter holder.
3. Apply a thin layer of clean hydraulic oil on the rubber gasket
of the new filter.
4. Fit manually the filter, first until the filter gasket manages to
reach the holder. Next, tighten it with one more turn.
5. Check the hydraulic oil level on the sight glass (2) and
adjust, if necessary. Refer to the section "Every 10 Hours"
to obtain further information.
6. Turn on the engine and check if the filter is well sealed.
Check the tires air pressure
To check the pressure, use an air pressure gauge. The
pressure in all the tires must be the same.
To know the recommended pressure values, refer to the
"Technical Specifications" section.
When replacing the tires, it is important that all of
them have the same original diameter and width,
otherwise they can slide into the wheel or make their
installation impossible.
Fig. - External/internal wheels
1. Air valve
1
Fig. - Hydraulic oil tank
1. Tank cap
2. Sight glass
1
2
1
