Dynapac CC 501, Operation

Page: 10 / 28

8 CC 501/501C O501EN3
INSTRUMENTS AND CONTROLS, FUNCTIONAL DESCRIPTION
Items Designation Symbol Function
in fig. 4
1 Directional indicator, Turn left to switch on the left directional indi-
switch (optional) cator. The function is OFF in the middle position.
2 Working lights, rear, Turn left to switch on the rear working lights.
switch (optional)
3 Hazard beacon, Turn right to switch on the hazard beacon.
contact (optional)
4 Driving lights, Switches ON the headlight and taillight.
switch (optional)
5 Hazard flashers, contact Turn right to switch on the flashing warning
(optional) lights.
6 Horn, contact Press to sound the horn.
7 -
8 Starter contact Press to run the starter motor.
9 Main power switch In position O, the electric circuit is broken.
In position I, all electric instruments and
controls except the starter motor circuit are
powered.
10 Brake warning lamp The warning lamp lights while the reserve/
parking brake is applied.
11 Reserve brake/ OFF (pulled-out mode) is normal during
Parking brake, operation. ON (pushed-in mode) applies the
(Red knob) brakes and stops the roller. Put the forward/
reverse level in neutral before attempting to
restart.
12 Warning lamp, oil pressure The warning lamp lights if lubricating oil pres-
- diesel engine sure is too low. Stop the engine and remedy
the cause. See engine manual.
13 Voltmeter Indicates voltage in the electrical system.
Normal indication is 12–15 Volt.
14 Fuel gauge Indicates the level of the fuel tank.
15 Temperature gauge, Indicates the temperature of the hydraulic fluid.
hydraulic fluid Normal temperature range 65°C–80°C
(149°F–176°F). Stop the engine if the meter
indicates more than 85°C (185°F) and
remedy the cause.
STOP