Dynapac CC 501, Operation

Page: 16 / 28

14 CC 501/501C O501EN3
BEFORE START, cont’d.
3
1
2
Operator’s seat - Setting
Fig. 9 Operator’s seat
1. Length adjustment
2. Seat-back setting
3. Cushioning adjustment
Position the operator’s seat so that the controls are
easily accessible.
The seat can be adjusted as follows:
- Lengthwise (1)
- Seat-back slope (2)
- Cushioning in relation to the operator’s weight (3)
9 11 12
13 14
Instruments and controls
- Check
Fig. 10 Instrument panel
9. Starter switch
11. Parking brake knob
12. Oil pressure lamp
13. Voltmeter
14. Fuel gauge
Speed control
1 1 2
Fig. 11 Speed limiting device
1. Setting knob
2. Disengagement device
Ensure that the parking brake knob (11) is pulled out.
Turn the starter switch (9) to position I.
Check that the voltmeter (13) goes up to at least 12
volt.
Check that the fuel gauge (14) gives a reading.
Check that the oil pressure lamp (12) lights.
The machine is provided with a speed control device
that can be disengaged for transportation driving.
Loosen the knob (1) on the speed control device. Set
the forward/reverse lever to the desired speed and
tighten the knob.
You can use the forward/reverse lever to bypass the
speed control by pulling out the speed control knob (2).