Dynapac CA3500DCP, Instruction Manual

Page: 110 / 178

Miscellaneous
4812165301.pdf 2022-09-02
Load carrier Load carrier
- When loaded, the vibratory roller is centered laterally on the platform (± 5 cm). - When loaded, the vibratory roller is centered laterally on the platform (± 5 cm).
- The parking brake is applied and in good working condition, and the articulated joint lock is
closed. - The parking brake is applied and in good working condition, and the articulated joint lock is
closed.
- The drum is placed on a rubber liner, so that the static friction between the surfaces is at least
0.6. - The drum is placed on a rubber liner, so that the static friction between the surfaces is at least
0.6.
- The contact surfaces must be clean, wet or dry, and free from frost, ice and snow. - The contact surfaces must be clean, wet or dry, and free from frost, ice and snow.
- The lashing mounts on the load carrier have LC/MSL at least 2 tonnes. - The lashing mounts on the load carrier have LC/MSL at least 2 tonnes.
Lashings Lashings
- The lashings comprise a lashing strap or chain with a permitted load (LC/MSL) of at least 1.7
tonnes (1,700 daN) and a pre-tension S
TF
of at least 300 kg (300 daN). The lashings are
re-tightened as required.
- The lashings comprise a lashing strap or chain with a permitted load (LC/MSL) of at least 1.7
tonnes (1,700 daN) and a pre-tension S
TF
of at least 300 kg (300 daN). The lashings are
re-tightened as required.
- Each of lashings 1-3 is either a double or two single lashings. A double lashing runs in a sling
through a lashing point or around a machine part and down into two different mounts on the
platform. - Each of lashings 1-3 is either a double or two single lashings. A double lashing runs in a sling
through a lashing point or around a machine part and down into two different mounts on the
platform.
- Lashings in the same direction are placed in different lashing mounts on the trailer. Lashings
that are pulled in opposite directions may be placed in the same lashing mount, however. - Lashings in the same direction are placed in different lashing mounts on the trailer. Lashings
that are pulled in opposite directions may be placed in the same lashing mount, however.
- The lashings are as short as possible. - The lashings are as short as possible.
- The lashing hooks must not lose grip if the lashings become slack. - The lashing hooks must not lose grip if the lashings become slack.
- The lashings are protected against sharp edges and corners. - The lashings are protected against sharp edges and corners.
- The lashings are located symmetrically in pairs on the right and left sides. - The lashings are located symmetrically in pairs on the right and left sides.
98