Dynapac CA 302, Instruction Manual

Page: 60 / 121

Operation
ICA302-4EN4.pdf 2012-04-12
Operating on difficult surfaces (Optional)
Drive, drum/wheels
35
Fig. Control panel
35. Speed selector, drum/wheels
(Optional)
2. Position 2
3. Position 3
2 3
If the machine should get stuck and it is equipped with
a 2-speed drum drive, set the drive knob as shown
below.
If the drum spins: Turn the knob (35) to Position 2
If the rear tires spin: Turn the knob (35) to Position 3.
When the machine has regained its grip set the knobs
in their original positions.
Vibration
Amplitude/frequency - Changeover
24
Fig. Instrument panel
24. Amplitude selector Low/0/High
There are two drum vibration settings. Use the switch
(24) to adjust.
Turn the knob to the left for low amplitude/high
frequency and to the right for high amplitude/low
frequency.
Setting the amplitude may not be performed
when vibration is in operation.
Switch the vibration off first and wait until
vibration stops before setting amplitude. Setting the amplitude may not be performed
when vibration is in operation.
Switch the vibration off first and wait until
vibration stops before setting amplitude.
50